Questions for the CLSSGB-001 were updated on : Nov 21 ,2025
This output is what type of advanced Capability Analysis?
B
Conducting a viable Capability Analysis using Attribute Data one must obtain a fairly large sample set
to be statistically sound.
A
A Stable process is a process whose output is consistent over time. A primary tool used to analyze
Stability would be a ________________.
D
The reported Cpk for a process with an average of 94 units, a spread of 22 units and upper and lower
specification limits of 125 and 80 units would be?
B
Process Capability is a function of which of these?
D
The ability to repeat the same measurement obtained with one measurement instrument used
several times by one appraiser while measuring the identical characteristic on the same part is
known as ____________.
A
The deviation of the measured value from the actual value regardless of the operator is known as
______________.
B
As a type of measurement error, Linearity describes a change in accuracy through the expected
operating range of the measurement instrument.
A
The Accuracy of a Measurement System addresses _________________.
A
Measurement System Analysis is a procedure used to quantify all ____________ in the method or
system used for taking measurements.
C
Measurement error is defined as the effect of all sources of measurement variability that caused an
observed or measured value to deviate from the __________.
D
A Belt gathered the following defect data for a shoe production line and wanted to assemble it into a
Pareto Chart. The correct order from left to right in the chart would be:
Data:
Cutting38
Forming17
Stitching56
Sealing42
C
The Z score is a measure of the distance in Standard Deviations of a sample data point from the
Median of the sample population.
B
Long-term Data represents all the variation that one can expect within the subject process.
A
If the data displayed in a Histogram displays two peaks the distribution would likely be
_____________.
D